Page 1 of 1
Skinny Paipo
Posted: Tue Jun 30, 2020 9:24 pm
by Thumper
Just finished a 12” wide board it’s just under 4ft long 12mm ply has anyone played with narrow boards.
Re: Skinny Paipo
Posted: Wed Jul 01, 2020 9:55 am
by Uncle Grumpy
I made a 15" x 5'5" alaia style board a few years back. It's the one I use when the surf is small.
- IMGP3352.JPG (154.46 KiB) Viewed 6086 times
Re: Skinny Paipo
Posted: Mon Jul 13, 2020 1:01 pm
by Papa Paepo o
beautiful 5'5" piece of wood alaia.....
Re: Skinny Paipo
Posted: Thu Jul 30, 2020 2:01 pm
by Poobah
Poplar board I made several years ago. The template was copied directly from a vintage Crest board from Penzance. The nose kick was done by soaking the nose of the board for a few days, boiling the nose for 20 to 30 minutes, then clamping, and left in clamps for a day.
Note: after this photo was taken, I used a spade bit to drill two shallow holes into the bending block, so the C-clamps wouldn't slip around.
Re: Skinny Paipo
Posted: Fri Jul 31, 2020 2:13 am
by SURFFOILS
Thumper, I made a 12 inch wide board but found it needed a lot of power to plane and sunk once your foot was off the gas.
Re: Skinny Paipo
Posted: Mon Aug 10, 2020 2:57 am
by Thumper
Hi foil been testing the 12” paipo and find it has really high top end speed down the line but I have to bend it to turn , I found this out by watching jack johns video on the original surfboard company site he’s pretty good check it out.