New EPS Board

What works and what doesn't. Share design ideas, references and contacts for paipo board builders.
flojo
Big Wave Charger
Posts: 73
Joined: Mon May 14, 2012 1:54 am
City: pacifica
State or Province: california
Country: usa
Location: pacifica, ca

Re: New EPS Board

Unread post by flojo » Thu Jun 19, 2014 3:06 am

Hey jbw, did you treat the surface of your shaped blank with anything prior to glass job?
On other posts in this forum, I saw mention of spackle or micro balloons being applied.
Did you find this necessary?

jbw4600
Big Wave Charger
Posts: 289
Joined: Sat Nov 05, 2011 6:08 pm
City: Kentfield
State or Province: CA
Country: USA
Location: Fairfax, CA
Contact:

Re: New EPS Board

Unread post by jbw4600 » Wed Jun 25, 2014 7:55 pm

Hi, Sorry for the delay. I was out of town. Yes I made a thin slurry of epoxy and micro ballons. That is what most people are doing these days.

flojo
Big Wave Charger
Posts: 73
Joined: Mon May 14, 2012 1:54 am
City: pacifica
State or Province: california
Country: usa
Location: pacifica, ca

Re: New EPS Board

Unread post by flojo » Sat Jun 28, 2014 2:58 am

Hey..thanks for the reply...nice board by the way

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest