Help me shape this board

What works and what doesn't. Share design ideas, references and contacts for paipo board builders.
User avatar
PaipoRick
Big Wave Charger
Posts: 51
Joined: Sat Aug 20, 2011 8:29 pm
City: City
State or Province: Your state or province
Country: Your country
Location: Asheville, NC

Help me shape this board

Unread post by PaipoRick » Wed Apr 23, 2014 8:39 pm

It's a piece of local paulownia, which they call princess tree here in NC. Anyway, it's 1" thick. The short side in the picture is 38" long, the long side is 48". Width is around 17". The edges taper a little due to the log it was cut from. I got this from a friend who builds furniture. The wood is rough and will need a trip through a planer, which we have at work.

Anyway, I'd like to keep this as one solid piece of wood. For a shape I was going to square the tail off, make the rails sort of parallel, and round off the nose a bit. I'd like to keep this as one solid section.

Image

User avatar
bgreen
Big Wave Charger
Posts: 1090
Joined: Fri Aug 19, 2011 5:17 pm
City: Brisbane
State or Province: Qld
Country: Oz
Contact:

Re: Help me shape this board

Unread post by bgreen » Mon Apr 28, 2014 4:24 pm

Sounds like a plan. Once it's been through the planer it will be clearer what you have to work with, e.g thickness. You might like to consider a tail block if you are sticking with a single piece of wood.

Bob

User avatar
krusher74
Big Wave Charger
Posts: 790
Joined: Wed Nov 07, 2012 3:53 pm
City: easkey
State or Province: co sligo
Country: Ireland
Interests: Surfing, vintage cars and motorbikes
Location: Easky, Co sligo , ireland
Contact:

Re: Help me shape this board

Unread post by krusher74 » Sat May 10, 2014 5:53 pm

alaia hull with wegner surfie plan shape! :D
Attachments
tail.jpg
tail.jpg (30.19 KiB) Viewed 1322 times
surfie.jpg
surfie.jpg (122.47 KiB) Viewed 1322 times

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests