For you diehard, finless, p-boarders (you know who you are)
http://www.foamez.com/marko-foam-body-b ... p-679.html
Just take a little off here and a little off there, throw some cloth and epoxy resin on it, and bingo. Get fancy and put in your own stringer, or use a strip of carbon-fiber, possibilities are endless.
EPS Body Board Blank
- nomastomas
- Big Wave Charger
- Posts: 597
- Joined: Thu Nov 17, 2011 2:30 am
- City: Ojai
- State or Province: CA
- Country: USA
- Interests: Surfing, cycling and fishing
- Location: Ojai, CA
- Contact:
EPS Body Board Blank
"This is a paipo site...isn't it?"
www.tp4surf.com
www.tp4surf.com
- bgreen
- Big Wave Charger
- Posts: 1232
- Joined: Fri Aug 19, 2011 5:17 pm
- City: Brisbane
- State or Province: Qld
- Country: Oz
- Contact:
Re: EPS Body Board Blank
Too short for me, but then again, maybe I'm not a diehard. I have a foot in both camps.
Bob
Bob
- krusher74
- Big Wave Charger
- Posts: 842
- Joined: Wed Nov 07, 2012 3:53 pm
- City: easkey
- State or Province: co sligo
- Country: Ireland
- Interests: Surfing, vintage cars and motorbikes
- Location: Easky, Co sligo , ireland
- Contact:
Re: EPS Body Board Blank
"This blank is designed to make bodyboards, hard and soft."
I would be interested in what they consider the finishing process for a "soft" board
I know bodyboards dont use eps cores (maybe the really cheap ones do?) , and have no idea if the outer materials usually used will work with eps?
certainly cheap!
I would be interested in what they consider the finishing process for a "soft" board
I know bodyboards dont use eps cores (maybe the really cheap ones do?) , and have no idea if the outer materials usually used will work with eps?
certainly cheap!
http://www.sdfsurfboards.co.uk/ built my paipo!
- nomastomas
- Big Wave Charger
- Posts: 597
- Joined: Thu Nov 17, 2011 2:30 am
- City: Ojai
- State or Province: CA
- Country: USA
- Interests: Surfing, cycling and fishing
- Location: Ojai, CA
- Contact:
Re: EPS Body Board Blank
I used a couple of these eps blanks for 44" models, but I had to flip the outline to make my wide-point back shapes fit. I also used it bottom-side up to get the rocker I wanted. 2.0PCF EPS shapes really nice and you don't really need a stringer. Price is right...
"This is a paipo site...isn't it?"
www.tp4surf.com
www.tp4surf.com
Who is online
Users browsing this forum: No registered users and 70 guests