Glassings a breeze...
Using a small vac pump and a plastic bag,
I cut a piece of glass for either side of the ply,
wet both sides out with epoxy resin
and put all that in a plastic bag with a tube that connects to the pump.
The pump sucks the air out of the bag but it also sucks the plastic and the glass on to the ply and draws away excess resin so you end up with a glass job that sticks exactly to the shape and doesn't carry excess resin that makes it heavier than it needs to be. You only throw away a plastic bag and a bit of sticky tape and there's no resin to clean up or scrape off the floor like standard laminations.
A few hours later it comes out of the bag and it's done, But epoxy resin needs a few days to harden to its maximum.
In one shot you can glass both sides of anything and get a quality item with little skill, thankfully.
I still need to trim around the edges, maybe add a bit of artwork and then it's ready to ride.